Filter
Top Products
1993 Volvo 850 GLT
bolts counterclockwise to loosen.
● Fold out the crank handle on the jack by pressing the nob on the handle downward. To attach the jack,
refer to the illustration on the following page.
NOTE: To avoid excessive wear and the necessity of rebalancing, mark and reinstall wheels in same
location and position as before removal. To lessen the chance of imbalance, each wheel hub is equipped
with a guide stud to ensure that a removed wheel can be reinstalled in its original position (as when
changing over to winter tires/wheels).
pg. 6:3 Wheel changing (cont.)
There is a jack attachment located in the center on each side of the car. Position the jack on the bar in the
attachment as shown in the illustration above and crank while simultaneously guiding the base of the
jack to the ground. The base of the jack must be flat on a level, firm, non-slippery surface. Before raising
the car check that the jack is still correctly positioned in the attachment . Raise the vehicle until both
wheels on the side of the car where the jack is attached are lifted off the ground. Unscrew the wheel
bolts completely and carefully remove the wheel so as not to damage the tread on the studs.
Jack attachment
Installing the wheel
file:///K|/ownersdocs/1993/1993_850GLT/93850_6_1.html (2 of 4)12/30/2006 9:43:05 AM