Filter
Top Products
1985 Volvo 740 GL, GLE, Turbo
clockwise and tighten lightly. The bevelled side of the nuts should face the wheel. Lower the vehicle to
the ground and alternately tighten the nuts to 63 ft. Ibs. (85 Nm). Install the wheel cap.
Some models have a hub cap that extends to the wheel rim. The valve symbol on the inside of the hub
cap should be installed toward the valve.
pg. 64 Replacing bulbs
NOTE:
The method for replacement of bulbs in the various lighting units is shown on the following pages.
Make sure when installing bulbs, that the guide pin on the socket fits into its corresponding recess.
When installing Halogen bulbs, do not touch the glass with your fingers. The reason for this is that
grease, oil or any other impurities can be carbonized onto the bulb and damage the reflector.
Use bulbs of correct type and voltage. Failure to do so could cause the bulb failure warning light to
activate.
Replacing sealed beam headlamp units
1. Squeeze the clip and pull it upwards.
2. Lift up the rim slightly and remove it forwards.
3. Remove Phillips screws and rim. Lift out the headlamp unit.
4. Disconnect the socket contact.
file:///K|/ownersdocs/1985/1985_740_GL_GLE_Turbo/85740_05.htm (4 of 16)12/30/2006 7:46:09 AM