Filter
Top Products
1985 Volvo 740 GL, GLE, Turbo
3 If there is a longer scratch, you may want to protect surrounding paint by masking it off.
Touching up damaged paint on fender edges and sills
Material:
Rust remover
Primer - spray
Surface finish - spray
Sand paper (H 150 - 300 grit)
Thinner
NOTE: When touching up the car, it should be well cleaned and dry and have a temperature exceeding
60°F (+15°C).
Mask with tape and paper prior to painting larger surfaces. Remove the masking immediately after
application of the last paint coat, before the paint starts to dry.
Touching up is as follows:
1. Remove paint flakes.
2.Sand the damaged surface and wash it clean with thinner.
Apply the rust remover. (Avoid contact with skin!). Wait a few minutes and then rinse carefully with
water and wipe dry.
3. Shake the spray can for at least 1 minute. Spray on the primer. Move the can slowly and evenly back
and forth over the spot and about 8-12 in. (20-30 cm) from the surface. Protect the surrounding surfaces
with suitable paper.
NOTE!
Spray painting should be done in a well ventilated and dust-free area.
4. When the primer has dried, apply the surface enamel in the same way. Spray on several times and
allow the paint to dry a minute or so between each application.
pg. 82 Washing
file:///K|/ownersdocs/1985/1985_740_GL_GLE_Turbo/85740_06.htm (6 of 9)12/30/2006 7:46:10 AM