Filter
Top Products
14
W6202pr-0920
• Your Power Wheels
®
battery is a non-spillable sealed
lead-acid battery. It must be recycled or disposed of in
an environmentally sound manner.
• Do not dispose of a lead-acid battery in a fire. The
battery may explode or leak.
• Do not dispose of a lead-acid battery in your regular,
household trash. The incineration, landfilling or mixing
of sealed lead-acid batteries with household trash is
prohibited by law in most areas.
• Protect the environment by not disposing of this
product with household waste (2002/96/EC). Check
your local authority for recycling advice and facilities
(Europe only).
• Return an exhausted battery to a federal or state approved
lead-acid battery recycler, such as a Power Wheels
®
authorized service center or a local seller of
automotive batteries. For the authorized service
center location nearest to you, please visit us online
at www.powerwheels.com or call 1-800-348-0751.
Contact your local waste management officials for
other information regarding the environmentally
sound collection, recycling and disposal of lead-acid
batteries. If you live in the State of Florida or the State
of Minnesota, it is prohibited by law for anyone to
throw away lead-acid batteries in the municipal
waste stream.
If a battery leak develops, avoid contact with the
leaking acid and place the damaged battery in a plastic
bag. See next section for proper disposal.
If acid comes in contact with skin or eyes, flush with
cool water for at least 15 minutes and call a physician.
If acid is internally ingested, give water, milk of
magnesia or egg whites immediately. Never give emetics
or induce vomiting. Call a physician.
• Do not allow the battery to run down completely
before charging.
• Charge the battery before storing the vehicle, and at
least once per month, even if the vehicle has not
been used.
• Charge the battery after each use, regardless of how
long the vehicle was used.
• Leaving the battery in a discharged condition will
ruin it.
• Always remove an exhausted battery from the vehicle.
Battery leakage and corrosion can damage the vehicle.
• Do not store the battery in temperatures above 75° F
or below -10° F.
BATTERY DISPOSAL
• Check all screws and their protective coverings
regularly and tighten as required. Check plastic parts
on a regular basis for cracks or broken pieces.
• During snowy or rainy weather, the vehicle should be
stored inside or under a protective cover.
• Avoid operating the vehicle in wet or snowy
conditions, and do not spray the vehicle with a hose.
Water or moisture in the motors or electrical switches
can cause them to corrode, and could cause switch or
motor failure.
• Avoid operating the vehicle on sand, loose dirt or
gravel. Sand, loose dirt or gravel in the motors or
electrical switches can cause them to jam, and could
cause switch or motor failure.
• The vehicle can be wiped down with a soft, dry cloth.
For a shiny finish, you can wipe plastic parts with
a non-wax furniture polish applied to a soft cloth.
Do not use automotive wax. Do not use soap and
water or spray the vehicle with a hose.
• To ensure your vehicle stays in good operating order,
we recommend you periodically have your vehicle
checked by a Power Wheels
®
authorized service center.
BATTERY CARE VEHICLE CARE
(United States Only)
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Note: Changes or modifications not expressly approved
by the manufacturer responsible for compliance could
void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC STATEMENT