Filter
Top Products
VIVOTEK
100 - User's Manual
Custom Command
If Custom Camera (scanner) is selected as the PTZ driver, you will need to congure command
buttons to control the PTZ scanner� Click Custom Command to open the Custom Command
page to set the commands in the Control Settings session� Please refer to your PTZ scanner's
documentation to enter the commands in the following elds. Click Save to enable the settings and
click Close to exit the page�
►The command buttons will be displayed on the main page:
►If you select Pelco D protocol as the
PTZ driver, the Control Settings
column will not be displayed�
►For all PTZ drivers, a total of five
additional command buttons can be
congured.
NOTE: