Filter
Top Products
12
©
2000 Directed Electronics, Inc.
Valet
®
Mode. You must also know where the Valet
®
switch is
located. Be sure to check with your installer at the time of instal-
lation for the location of the Valet
®
switch.
To enter or exit Valet® Mode with the Valet switch:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet
switch within 10 seconds.
The status LED will light solidly if you have entered Valet Mode,
and it will go out if you have exited Valet Mode.
You may also enter or exit Valet Mode using your remote.
Remember, the system must be disarmed in order to enter Valet
®
Mode. The operations described in this section refer to transmitter
buttons. These buttons correspond to a Standard Configuration
transmitter. This may not be how your transmitter is set up.
1. Open any vehicle door.
2. Press .
3. Press .
4. Press again.
The status LED will light solidly if you have entered Valet Mode,
and it will go out if you have exited Valet Mode.
Remote Valet
®
DRW-35