Filter
Top Products
© 2000 Directed Electronics, Inc. Vista, CA 33
transmitter/receiver learn routine
™
The system comes with two transmitters that have been taught to the receiver. The receiver can store up to four
different transmitter codes in memory. Use the following learn routine to add transmitters to the system or to
change button assignments if desired.
Using the optional DEI® Bitwriter™ or PC Interface, the learn routine may be locked. Make sure the learn routine
is unlocked before programming features. If the siren generates one long chirp when attempting to program the
unit, the learn routine is locked and must be unlocked using the DEI® Bitwriter™ or PC before proceeding.
The Valet®/Program button, plugged into the blue port, is used for programming. There is a basic sequence to
remember whenever programming this unit: Door, Key, Choose, Transmit and Release.
1. Open a door. (The GREEN wire, H1/5, or the VIOLET, H1/7 must be connected.)
2. Key. Turn the ignition on. (The heavy gauge PINK wire of the relay satellite must be con-
nected.)
3. Select the receiver channel. Press and release the Valet®/Program switch the number of
times necessary to access the desired channel. Once you have selected a channel, press and
HOLD the Valet®/Program switch once more. The siren will chirp and the LED will blink the
number of times corresponding to the channel that has been accessed.
NOTE: If adding a remote, a button must be taught to the unit in the Channel One or Channel Five
position prior to programming other channels.
CHANNEL NUMBER FUNCTION WIRE COLOR
1 Arm/Disarm/Panic
2 Silent Mode™/Remote Valet®/Trunk Release RED/WHITE
3 Remote Start
4 Second unlock or other accessories VIOLET/BLACK
5 Arm only
6 Disarm only
7 Panic only
8 Auto Learn Standard Configuration* (default)
9 Auto Learn Single Button Arm/Disarm Configuration*
10 Delete all transmitters
*NOTE: For Auto Learn Configurations, see Transmitter Configurations section of this guide.