Filter
Top Products
40 © 2000 Directed Electronics, Inc. Vista, CA
feature descriptions
The features of the system are described below. Features that have additional settings that can be selected only
when programming with the PC interface or Bitwriter are indicated by the following icon:
1-1 ACTIVE/PASSIVE ARMING: When active arming is selected, the system will only arm when the transmitter
is used. When set to passive, the system will arm automatically 30 seconds after the last door is closed. To alert
the consumer of passive arming, the siren will chirp 20 seconds after the door is closed. This provides the con-
sumer with an audible warning prior to the system actually arming. At the 30 second mark, the system will arm,
but the siren will not chirp.
1-2 CHIRPS ON/OFF: This feature controls the chirps that confirm the arming and disarming of the system.
1-3 IGNITION CONTROLLED DOOR LOCKS ON/OFF: When turned on, the doors will lock three seconds after
the ignition is turned on and unlock when the ignition is turned off. The TechSoft Programmer or the 998T
Bitwriter™ will display separate steps for ignition lock and ignition unlock. They can be programmed on or off
independently.
menu #1 - basic features
FEATURE ONE-CHIRP SETTING (DEFAULT) TWO-CHIRP SETTING
3-1 Engine checking on Engine checking OFF
3-2 Engine checking TACH Engine checking VOLTAGE
3-3 Run time: 12 minutes* Run time: 24 or 60 minutes*
3-4 Parking lights flashing Parking lights constant
3-5 Crank time 0.6 seconds 0.8, 1.0, 1.2, 1.6, 1.8, 2.0, 4.0
3-6 Voltage check - high Voltage check - low
3-7 Auxiliary output - factory disarm Special accessory
3-8 Status output Factory re-arm output
3-9 Anti-grind ON Anti-grind OFF
menu #3 - remote start options