Filter
Top Products
EVAPORATOR INSTALLATION
ON A WORK BENCH, INSTALL EVAPORATOR REAR BRACKET AND HARDLINES WITH PROPERLY LUBRICATED O-RINGS.
(SEE FIGURE 10, PAGE 11, AND FIGURE 15, PAGE 16.)
REMOVE 2 OEM HEATER PLUGS IN FIREWALL, SEE FIGURE 7 PAGE 9.
INSTALL FRONT MOUNTING BRACKET ON EVAPORATOR USING (2) 1/4-20 X 1/2 HEX BOLTS AND TIGHTEN AS
SHOWN IN FIGURE 5 BELOW.
LIFT EVAPORATOR UNIT UP UNDER THE DASHBOARD SEE FIGURE 6. SECURE LOOSELY TO THE FIREWALL FROM THE
ENGINE COMPARTMENT SIDE USING (2) 1/4-20 NUT AND WASHER, SEE FIGURE 6 BELOW.
USING (2) #14 X 3/4 SHEET METAL SCREW w/ 1/4 FLAT WASHER SECURE THE FRONT EVAPORATOR MOUNTING
BRACKET TO THE INNER COWL. SEE FIGURE 6 BELOW.
VERIFY THAT EVAPORATOR UNIT IS LEVEL AND SQUARE TO THE DASH, THEN TIGHTEN ALL MOUNTING BOLTS.
(NOTE: TIGHTEN THE BOLT ON FIREWALL FIRST, THEN THE FRONT MOUNTING BRACKET SCREWS.)
8
1969-70 MUSTANG w/o AC GEN IV
901271 REV A 2/11/08, 69-70 MUSTANG w/o AC GEN IV EVAP INSTR PG 8 OF 26
USE TEMPLATE PROVIDED ON PAGE 25. ALIGN TEMPLATE WITH OEM BLOWER MOTOR MOUNTING
HOLES & DRILL (6) 3/16 HOLES IN FIREWALL FROM INSIDE UNDER DASH, SEE FIGURE 5a.
FIGURE 5
FIGURE 5a
EVAP
FRONT
BRK
T
641
271
DRIVER SIDE EVAP
MOUNTING HOLE
FIGURE 6
(2) #
14 X
3/4
SHE
ETMET
AL
SCREW
w/ 1
/4
FLA
T W
ASHER
PASSENGER SIDE EVAP
MOUNTING HOLE
S
B
Y
1969-7
0 MUST
ANG w/o AC
FIREWALL COVE
R
HOLE TEMPL
ATE
THIS SIDE IN
SIDE OF CAR
(6) 3/16
HOLES
OEM HEATER
HOLE
BLOWER MOTOR
MOUNTIN
G
HOLE
BLOWER
MOTOR
MOUNTING
HOLE
BLOWER
MOTOR
MOUNTING
HOLE
BLOWER
MOTOR
MOUNTING
HOLE
(4) ALIG
NMENT HOLES
OEM HEATER
LINE HOLES
DRIVER SIDE EVAP
MOUNTING HOLE
PASSENGER SIDE EVAP
MOUNTING HOLE