Filter
Top Products
TEMPLATE
DEFROST DUCT/ FRESH AIR CAP INSTALLATION
INSTALL DEFROST DUCT UNDER DASH AS SHOWN IN FIGURE 3 BELOW. SECURE USING OEM NUTS
w/ (3) 3/16 SAE FLAT WASHERS.
HOLD FRESH AIR CAP UNDER DASH AND MARK THE (3) MOUNTING HOLES.
DRILL (3) 1/8” MOUNTING HOLES UNDER DASH.
A
PPLY A 1/4” BEAD OF SILICONE AROUND THE BACK SIDE OF THE FRESH AIR CAP AS SHOWN IN
FIGURE 3, BELOW.
SECURE FRESH AIR CAP TO FRESH AIR HOLE USING (3) #10 X 1/2 SHEET METAL SCREWS AS SHOWN
IN FIGURE 3 BELOW.
7
1969-70 MUSTANG w/o AC GEN IV
DEFROST
DUCT
605169
(3) 3/16
SAE FLAT
WASHERS
(3) OEM
STAR NUTS
DRILL
HOLES
FRESH AIR
CAP
605174
(3) 10 X 1/2
SHEET METAL
SCREW
SILICONE
DRIVER AND PASSENGER SIDE LOUVER INSTALLATION
CUT OUT TEMPLATE PROVIDED ON PAGE 22. PLACE THE DRIVER SIDE TEMPLATE ON THE DASH BY
ALIGNING THE LEFT SIDE OF THE TEMPLATE AGAINST THE EDGE OF THE DASH, THEN ALIGN THE
BOTTOM OF THE TEMPLATE TO BOTTOM OF DASH AS SHOWN IN FIGURE 4.
CUT OUT TEMPLATE PROVIDED ON PAGE 23. PLACE THE PASSENGER SIDE TEMPLATE ON THE DASH
BY ALIGNING THE RIGHT SIDE OF THE TEMPLATE AGAINST THE EDGE OF THE DASH, THEN ALIGN
THE BOTTOM OF THE TEMPLATE TO BOTTOM OF DASH AS SHOWN IN FIGURE 4.
ONCE TEMPLATE IS ALIGNED CORRECTLY, USE A CENTER PUNCH TO MARK THE HOLE ON THE
DASH. REMOVE TEMPLATE. USE A 2 3/4 HOLE SAW TO CUT HOLE IN DASH, SEE FIGURE 4 BELOW.
INSTALL LOUVERS IN DASH AS SHOWN IN FIGURE 4a BELOW.
FIGURE 3
FIGURE 4
FIGURE 4a
DRILL 2 3/4
HOLE
DRIVER SIDE
PASSENGER SIDE
DRILL 2 3/4
HOLE
LOUVER
490535
LOUVER BEZEL
605181
LOUVER BRKT
642075
2 1/2 HOSE
ADAPTER
DASH
TEMPLATE
901271 REV A 2/11/08, 69-70 MUSTANG w/o AC GEN IV EVAP INSTR PG 7 OF 26