Uniden UBC248CLT Automobile Electronics User Manual


 
5
10. DELAY Key Turns Delay function. When Scan stops on a channel it causes scanner to
remain on that channel for 2 seconds before the scanning resumes to wait
for a possible reply.
11. ALARM Key Turns the Tone Alarm. Turns the Radio Alarm ON/OFF by pressing
the key more than 2 seconds.
12.
ALARM SET Key
Press more than 2 seconds to enter the Alarm Time Set mode.
13. TIME SET Key Press more than 2 seconds to enter the Present Time Set mode.
14. TIME Key Press to review the clock time and cancel the Alarm time set and Present
Time Set mode.
15. LOCKOUT Key Prevents scanning of the displayed channel. The L/O indicator appears
when the current channel is locked out.
Press LOCKOUT again to unlock the channel. Lockout is active only when
the scanner stops on an active channel or a channel selected in Manual
Mode.
16. AM/PM Key Select a.m. or p.m. when setting the clock time or alarm time.
17. PRIORITY Key Turns Priority mode ON/OFF. In Priority mode the scanner samples the
designated Priority Channel every 2 seconds while in Scan or Manual mode.
If a transmission on the designated Priority Channel is detected, the scanner
monitors that channel until no signal is present.
18. SEARCH Key Press to start searching.
19. LIMIT /Key Channel Down and Set Search, Frequency Limit in Search Mode.
20. SCAN Key Press to start CH scan.
21. MANUAL Key Press to stop scanning. Press MANUAL again to step to the next channel.
Also use for direct channel access by first entering the channel number and
then pressing MANUAL to go directly to that channel.
22. HOLD /Key Channel Up and Hold Search in Search Mode.