Filter
Top Products
Trimble R7/R8 GPS Receiver User Guide 19
Setting up the Receiver 3
Trimble R7 Operation
33.3 General guidelines
The following guidelines apply whenever you set up your receiver for
operation:
• When plugging in a Lemo cable, make sure that the red dots on
the receiver port and the cable connector line up. Never use
force to plug cables in, as this may damage the connector pins.
• When disconnecting a Lemo cable, grasp the cable by the
sliding collar or lanyard and pull the cable connector straight
out of the port. Do not twist the connector or pull on the cable
itself.
• To securely connect a TNC cable, align the cable connector
with the receiver receptacle and thread the cable connector onto
the receptacle until snug.
• Insert the internal batteries with the battery contacts facing the
CompactFlash/USB door. The undersides of the batteries have a
center groove for alignment when being inserted into the
receiver.