Filter
Top Products
2 Setting up and Running the ThunderBolt E
16 Trimble ThunderBolt E GPS Disciplined Clock User Guide
To view the Timing Receiver Status and Control information, select
Window/Receiver Status:
4. To specify the communications port and protocol for your office computer,
right-click in the bottom right of the Trimble GPS Monitor screen and then select
the required COM port and settings.
5. Connect the Bullet antenna to the ThunderBolt E using the provided antenna
interface cable.
6. Connect the DB-9M serial cable from the ThunderBolt E to DB-9F on your
computer.
7. Turn on the +24 V DC power source or plug in the AC/DC converter and then
turn on the power.
The Tx and Rx in the lower left of the status bar indicate the following:
– If the Tx blinks, the computer is transmitting commands to the receiver.
– If the Rx blinks, the computer is receiving reports from the receiver.