Filter
Top Products
Page 7
REMOTE VEHICLE STARTER
INSTALLATION MANUAL
6-pin Description Test For Wire
1-Yellow 30amp Starter Output This wire will test 0volts in off, accessory and in
the ignition position.12volts during start only.
2-Green 30amp Heat/Acc Output This wire will test 0volts in the off position 12-
14volts in the accessory and run positions and
0 volts during start
3-Red 30amp Power Input 12volts at ignition harness or from battery.
Supplies power for the ignition, selectable output
and park light relays.
4-Red 30amp Power Input 12volt power at ignition harness or from battery.
Supplies power for accessory and start relays
5-Blue 30amp Ignition Output This wire will test 0volts in the off and accessory
position 12volts in the ignition, start and run.
6-White 30amp Select Output Selectable output for 2nd Ign, acc or starter.
14 pin connector
Pin Number Function Description
1-Yellow Re-Arm 0.75 second Pulsed output when locked and on remote start
shutdown. Used for factory alarm re-arm. Programmable
output. See Menu 3
2-Orange St.kill and Negative output when locked and during remote start.
Anti-Grind Used for optional starter disable, and anti-grind relay.
Programmable output. See Menu 3
3-Brown Disarm 0.75sec pulsed output when Unlocked and pulse before
remote start activation. Used for Factory Alarm Disarm.
4-Red/Wht Trunk Hold the unlock button for 3 seconds. Output will stay on
until the unlock button is released (Max 5 seconds)
Programmable to -Park lights. See Menu 2
5-Wht/Violet GWR (-) Output while remote starter is activated. Used to
activate Anti-theft bypass modules.
6- Green (-) Door Pin Input to detect door opening. Connect to door pin that
switches to Negative when the door is opened.
7-Green/ Hood Pin Negative input from hood pin safety switch. Switch is
White grounded when the hood is opened. Must be connected.
8-Purple (+) Door Pin Input to detect door opening. Connect to door pin that
switches to 12volts when the door opened.
9-Pink Brake input Positive Brake Input. Used to detect the brake switch
being applied. Found at the brake switch connector.
10-Black Ground System Chassis Ground Input..
6 Pin Power Connector