Teac 36XX Remote Starter User Manual


 
Page 19
REMOTE VEHICLE STARTER INSTALLATION MANUAL
Menu 4- Tach Settings
Setting 1 Auto Tach Learn.
1) Perform a System Reset. See page 15.
2) Turn the ignition key on. (Park lights will turn on).
3) Start the vehicle, the LEDs on the antenna will come on when a proper tach signal is detected*.
4) After approximately 30-35 seconds the park lights will go out then will flash twice and the horn
(optional) will honk twice to confirm that a tach signal has been learned.
*If the LEDs do not come on, a proper signal is not detected. Try a different tach source and follow
steps 1 thru 4.
.
Setting 2 Over-Crank Adjustment.**
1) Enter Program Mode (turn ignition ON-OFF-ON-OFF-ON), press and release the Program Button.
2) Press and release the # button on the remote.
3) Press and release the Program Button twice. (LEDs will flash 2 times consecutively)
4) Press and hold the Program Button. The park lights flash and the horn will honk one time.
*Each time the park lights flash and the horn honks the setting is reduced.
5) Release the Program Button. (Exit Program Mode and test remote starter)
Setting 3 Under-Crank Adjustment.**
1) Enter Program Mode (turn ignition ON-OFF-ON-OFF-ON), press and release the Program Button.
2) Press and release the # button on the remote.
3) Press and release the Program Button three times. (LEDs will flash 3 times consecutively)
4) Press and hold the Program Button. The park lights will flash and the horn will honk one time.
*each time the park lights flash and the horn honks the setting is increased.
5) Release the Program Button. (Exit Program Mode and test remote starter)
**Repeat steps 1-5 if necessary.