Filter
Top Products
41
Viewing waypoints
To view waypoints:
1. In the Set menu, scroll to Route and press ENTER. The
route list is displayed.
2. Select a route with UP/DOWN and press ENTER. A list of
waypoints is displayed.
3. Select a waypoint with UP/DOWN and press ENTER. The
waypoint menu is displayed.
4. View is the first menu item. Press ENTER to select it. The
following waypoint information is displayed:
• Waypoint number: This tells you the waypoint order on
the route.
• Bearing and distance to the waypoint: These are
calculated from the current location or if the GPS is off,
from the previous location.
• Waypoint coordinates: The coordinates of the selected
waypoint.
NOTE: The information on the waypoint window differs depending on the chosen
Position format. (For more information, see section 3.2.6. Setting the position
format.)
• Waypoint altitude: The altitude of the selected waypoint.
You can also activate an additional data display with
START/DATA. The following information is displayed:
• Point type: = Waypoint and = alarm point
• Waypoint alarm radius (RAD): This is only used with
alarm points. If the alarm radius is 0, the alarm is not
activated.
Press START/DATA to exit the additional data display.
5. Press STOP/BACK to exit the waypoint information and
return to the waypoint list.