Filter
Top Products
8. CHECKING BOLTS, NUTS AND SCREWS
• Retighten loose bolts and nuts
• Check for fuel and oil leaks
• Replace damaged parts with new ones.
9. HIGH ALTITUDE ENGINE OPERATION
• Please have an authorized Subaru Robin service dealer modify this engine if it is to be run continuously above 5000 feet
(1500 meters). Failure to do so, may result in poor engine performance, spark plug fouling, hard starting, and increased
emissions.
• Carburetor modication by an authorized Subaru Robin service dealer will improve performance and allow that this
engine meets EPA (Environmental Protection Agency) and CARB (California Air Resources Board) emission standards
throughout its useful life.
• An engine converted for high altitudes can not be run at 5000 feet or lower. In doing so, the engine will overheat and
cause serious engine damage.
Please have an authorized Subaru Robin service dealer restore high altitude modied engines to the original factory
specication before operating below 5000 feet.
6. PREPARATIONS FOR STORAGE
1. DISCHARGE FUEL
If you do not use the engine more than 3 months, discharge fuel to prevent gum in the fuel
system and carburetor parts.
• Remove the fuel cup, place it over a container and open the fuel valve to discharge fuel
from the fuel tank.
• Remove he drain screw of the carburetor oat chamber and discharge fuel.
2. ENGINE OIL
• Change the engine oil with fresh oil.
• Remove the spark plug, pour about 5cc of engine oil into the cylinder, slowly pull the starter handle of the recoil starter 2
or 3 times, and reinstall the spark plug.
3. CLEAN AND STORE
• Slowly pull the recoil starter handle until resistance is felt and leave it in that position.
• Clean the engine thoroughly with an oiled cloth, put the cover on, and store the engine indoors in a well ventilated, low
humidity area.
▲
! WARNING Flame Prohibited