Filter
Top Products
3. PRE-OPERATION CHECKS
NOTE
Engine shipped from our factory is without oil.
Before starting engine, ll with oil. Do not overll.
1. CHECK ENGINE OIL
Before checking or relling engine oil, be sure the engine is located on a stable, level surface and stopped.
• Do not screw the oil gauge into the oil ller neck to check oil level. If the oil level is low, rell
to the upper level with the following recommended oil.
• 1 - Oil Gauge
• 2 - Upper Level
• 3 - Lower Level
• Use 4-stroke automotive detergent oil of API service class SE or higher grade.
• Select the viscosity based on the air temperature at the time of operation as shown in the
table.
2. CHECK FUEL
Do not refuel while smoking, near an open ame or other such potential re hazards. Otherwise re accident may occur.
NOTE
THIS ENGINE IS CERTIFIED TO OPERATE ON
AUTOMOTIVE UNLEADED GASOLINE.
• Stop the engine and open the cap.
• Close the fuel valve before lling the fuel tank.
• Do not ll above the fuel lter screen (as marked 2 ), or the fuel may overow when it heats up
later and expands.
• When lling the fuel tank, always use the fuel lter screen.
• After refueling, tighten the fuel cap (rotate clockwise) until it makes a physical stop, there will be
a relief in resistance just before the physical stop.
• Wipe off any spilled fuel before starting the engine.
▲
! WARNING
Fuel Tank Capacity
SP170/210 3.4L
Oil Capacity (Upper Level)
SP170/210 0.6 L