Filter
Top Products
38
4-3-9 Crankcase cover/governor gear
NOTICE
·Don’t reuse the crankcase gasket.
·Oil seal：a) Don’t reuse；b) Apply the lubrication oil on the lip when using；c) Put the oil seal into the
crankcase cover with special tool, don’t damage the edge of the oil seal；d) Apply the special lubrication oil
onto oil seal after assembling.
·Don’t reuse the oil drain plug washer, as can as possible use new one.
·Bolt（M6×30)： Loosen and tighten the bolts in a crisscross pattern， Especially when tightening, all bolts
should be tightened gradually and evenly up to specified torque. Bolt torque：10±2N.m。
·Governor gear：First, check governor gear for worn and damaged, then, assemble it.
·Governor spindle clip： Firmly insert governor spindle clip into the groove of the shaft when assembling.
·Governor slider： Insert the governor slider into the governor spindle and check the governor slider for
turning freely.
No. Description No. Description
1 Gasket 8 Bolt (M6×16)
2 Dowel-A type 9 Governor gear Assy.
3 Oil seal Φ27×Φ42×7 10 Governor flyweight
4 Drain plug 11 Flyweight spindle
5 Washer (Φ10×Φ15.8×1.5)
12 Spindle clip
6 Crankcase cover 13 Governor slide
7 Bolt (M6×30) 14 Washer (Φ37×Φ27.4×1)