Subaru A3100BE Automobile User Manual


 
1-10 Seat, seatbelt and SRS airbags
1) Bar
NOTE
1) Holder
With the seatback folded, attach the
tongue plate of each rear/second-row
seatbelt to the corresponding holder.
Do the same also before someone gets
into the third-row seat.
Head restraint adjustment
T Window side seats
To raise the head restraint, pull it up.
To lower it, push the head restraint down
while pressing the release button on the
top of the seatback.
The head restraint should be adjusted so
that the center of the head restraint is clos-
est to the top of the occupant’s ears.
When the seats are not occupied, lower
y Folding the seatback of the center
seat will expose the bar that re-
tains it in the raised position. Be
careful not to hurt yourself on it.
Especially, do not rest your finger
on the bar. Otherwise, when the
seatback is raised, your finger
could be pinched between the bar
and seatback and thus injured.
y Raise the seatback of the center
seat while taking care not to trap
your hands or other parts of the
body between the center seat and
window-side seat.
1
100681
Never drive the vehicle with the
head restraints removed because
they are designed to reduce the risk
of serious neck injury in the event
that the vehicle is struck from the
rear.
1
100362
The head restraint is not intended to
be used at the lowest position. Be-
fore sitting on the seat, raise the
head restraint to an appropriate po-
sition depending on your sitting
height.
100363