Filter
Top Products
8
If you want to fix the cradle on the
windshield permanently
The suction cup is affected in high/low
temperatures and may come off. If you want
to fix the cradle on the windshield
permanently, use the supplied adhesive tape
on the suction cup.
If the bottom of the cradle touches the
dashboard
Attach the supplied pad for protection.
Cut the pad to the appropriate size before
attaching.
Note
The adhesive tape is difficult to remove once
applied.
2 Connect the cradle to the car cigarette
lighter socket.
1Plug the car battery adapter into the DC IN
5.2V jack at the rear of the cradle.
2Insert the other end of the car battery
adapter fully into the car cigarette lighter
socket.
*Lights up when you turn the ignition on after
installation.
Note
Depending on the size or shape of the cigarette
lighter socket, connection may not be possible.
3 Align the 2 slots on the underside of
the unit with the tabs on the cradle,
then push to snap the unit into place.
Be sure the unit is securely locked in the
cradle (2 clicks).
4 Loosen the center knob, fine adjust
the angle so you can view the monitor
properly, then retighten.
Tip
You can also connect the unit to an outlet using the
supplied AC power adapter.
D
C
IN
5
.2
V
LED*
1st click
2nd click
To tighten
To loosen