Filter
Top Products
Remote Transmitter Description
The Galaxy 3000 Plus is supplied with two 5-button Remote Transmitters used to control system operations.
Note: Using the optional PC or Pocket PC interface with the network software, it is possible to reconfigure
the functionality of the transmitter buttons. The standard (default) setting for operation of the transmitters
is described below.
Button 1
Arms the system and when held for 2 seconds, activates the system’s Panic feature. Button 1 also
locks the doors when the system is in Valet Mode.
Button 2
Disarms the system. Pressing Button 2 again operates the Passenger Unlock feature (if installed).
Button 2 also unlocks the doors when the system is in Valet Mode.
Button 3
Activates the Auxiliary 1 output. This output will remain on for as long as the button is pressed.
Button 4
Activates the Auxiliary 2 output. This output will remain on for as long as the button is pressed.
Button 5
is the Page Shift button. The Page Shift button will change the function of Buttons 1 through 4
each time it is pressed, allowing access to additional features or multiple car operation. Pressing the Shift
Button then Button 3 activates the Channel 4 output.
Each time the Shift Button is pressed, the LED on the transmitter will illuminate and the transmitter
functions will shift to the next page, allowing access to another set of features. Once shifted to another
page (there are 4 pages total), the transmitter will remain on that page for 10 seconds or until a button is
pressed, then return to page 1. Each time a transmitter button is pressed and held, the LED will flash a
number of times to indicate from which page it is transmitting. Under normally operation, only pages 1 and
2 are used. Pages 3 and 4 are usually used for Two Car Operation (see page 3) or optional expansion
modules.
Page 2 - Galaxy 3000 Plus
Remote TTransmitters
Button 1 Button 2
Button 5
LED
Button 3 Button 4