Filter
Top Products
Galaxy 3000 Plus - Page 13
System WWiring
16-Pin Main Harness
Pin 1 BROWN WIRE: Siren Output (+) 3A. The Brown wire must connect to the siren’s red wire. The Black
siren wire must be grounded.
Pin 2 BLACK WIRE: Ground Input (-). The Black wire must connect to a solid chassis ground. Clean away
any paint or dirt to insure the best possible ground.
Pin 3 ORANGE WIRE: Armed Output (–) 500mA. The Orange wire provides a ground output while armed
to activate a optional circuit disable relay or other device such as a power window control module.
Pin 4 BLUE/BLACK WIRE: Optional Sensor Input (-). The Blue/Black wire can connect to the trigger
output of an optional sensor such as a glass breakage detector or radar sensor.
Pin 5 YELLOW WIRE: +12V Ignition Input. The Yellow wire must connect to a main ignition wire at the
ignition harness. This wire must show +12V when the ignition is on.
Pin 6 BROWN/WHITE WIRE: Horn Output (-) 500 mA. Connect to an optional relay to activate the
vehicle’s horn when the alarm is triggered.
Pin 7 BLACK/YELLOW WIRE: Auxiliary 3 Output (-) 500 mA. Connect to a relay for an optional feature
such as headlight activation, etc. This output may be programmed for momentary, timed, or latched
operation.
Pin 8 GRAY WIRE: Auxiliary 1 Output (-) 500 mA. Connect to a relay for an optional feature such as trunk
release, etc. This output may be programmed for momentary, timed, or latched operation.
Pin 9 WHITE WIRE: Parking Light Output (+/-) relay. Connect the White wire to the circuit that shows
+12V or ground only when the parking lights are on and set the internal parking light relay jumper to
the proper polarity. For parking light circuits exceeding 10 amps, a relay is required. For vehicle’s with
independent left and right parking light circuits, diodes must be installed to keep the circuits separate.
NOTE: Do not connect the WHITE wire to the vehicle’s headlight circuit.
Pin 10 RED WIRE: +12V Battery Input. The Red wire must be connected to a clean source of continuous
+12V power.
Pin 11 BLACK/WHITE WIRE: Dome Light Output (+/–) 7A relay. Connect to the wire that activates the
vehicle’s dome light, usually the door pin switch wire. NOTE: The dome light output can usually connect
to the same wire used for the door trigger input (See GREEN and VIOLET door trigger wires).
Pin 12 BLUE/WHITE WIRE: Passenger Unlock Output (-) 500 mA. Connect to an optional relay to unlock
the passenger doors when the system is configured for Driver Priority Unlocking.
Pin 13 WHITE/RED WIRE: Auxiliary 2 Output (-) 500 mA. Connect to a relay or module for an optional
feature such as power window activation or remote start, etc. This output may be programmed for
momentary, timed, or latched operation.
Pin 14 VIOLET WIRE: Positive door trigger Input (+). Connect to the door switch circuit wire that shows
+12V when the door is open. This type of door circuit is usually found on Ford vehicles.
Pin 15 GREEN WIRE: Negative door trigger Input (-). Connect to the door switch circuit wire that shows
ground when the door is open.
Pin 16 BLUE WIRE: Trunk/Hood trigger Input (-). Connect the Blue wire to the trunk and/or optional hood
pin switches. The switch must provide a ground output when switch is opened. If the optional
remote start module is installed, connect the blue wire to the trunk pin switch only and connect the
hood pin input on the remote start module to the hood pin switch only.