Filter
Top Products
Remote Transmitter Description
The Galaxy Starter is supplied with two 5-button Remote Transmitters used to control system operations.
Note: Using the optional PC or Pocket PC interface with the network software, it is possible to reconfigure
the functionality of the transmitter buttons. The standard (default) setting for operation of the transmitters
is described below.
Button 1
Locks the doors and when held for 2 seconds, activates the system’s Panic feature.
Button 2
Unlocks the doors. Pressing Button 2 again operates the Passenger Unlock feature (if installed).
Button 3
Activates the Auxiliary 1 output. This output will remain on for as long as the button is pressed.
Button 4
Activates the Remote Start feature.
Button 5
is the Page Shift button. Each time the Shift Button is pressed, the LED on the transmitter will
illuminate and the transmitter functions will shift to the next page, allowing access to another set of
features. Once shifted to another page (there are 4 pages total), the transmitter will remain on that page
for 10 seconds or until a button is pressed, then return to page 1. Each time a transmitter button is pressed
and held, the LED will flash a number of times to indicate from which page it is transmitting. Under
normally operation, only pages 1 and 2 are used. Pages 3 and 4 are usually used for Two Car Operation
(see page 3) or optional expansion modules.
Shift then Button 1
Locks the system silently (only used if the optional audible status output is used).
Shift then Button 2
Unlocks the system silently (only used if the optional audible status output is used).
Shift then Button 3
Activates the Auxiliary 2 output. This output will remain on for as long as the button is
pressed.
Shift then Button 4
Activates the Auxiliary 3 output. This output will remain on for as long as the button is
pressed.
Page 2 - Galaxy 2000RS Plus
RReemmoottee TTrraannssmmiitttteerrss
Button 1 Button 2
Button 5
LED
Button 3 Button 4