Filter
Top Products
Page 16 - Galaxy 2000RS Plus
14. Engine Sense Mode. Selects between Tachless and Tach Monitor operation.
Tachless. Determines the engine status using an advanced software routine, without requiring
connection to the vehicle’s tachometer. Tachless operation may not be compatible with some vehicles
or in severe temperatures, in which case the tach wire must be connected.
T
ach Monitor. Monitors the vehicle’s tach wire (or a fuel injection wire) in real-time to determine engine
status and adjust starter crank time automatically. If programmed for Tach Monitor, the vehicle’s tach
signal will have to be learned before initial operation (see below).
15. Remote Start Program. This dual program branch sets the engine mode for Gas or Diesel, and
learns the vehicle’s RPM threshold. For installation into a diesel equipped vehicle, first set the engine
type to diesel before learning RPM.
RPM Learn. After engine type is set, start the engine, re-enter Branch 15, LED will start flashing if tach
signal is detected, otherwise the LED will stay solid. Press Button 1 to learn the vehicle’s idle speed.
The siren will chirp once to confirm. The siren will chirp four times if the tach signal was not learned.
Gas Engine.
Sets the engine type for Gasoline.
Diesel Engine. Sets the engine type for Diesel and monitors the glow plug input to make sure the glow
plugs are warm before cranking the starter. If the glow plug wire is not connected, the built-in timer
waits 15 seconds before automatically cranking the starter.
16. FM Transmitter Program.* Programs the optional FM module and transmitter into the system.
FM Module Learn.
Learns the add-on FM module ID so the FM transmitter can operate the system. The
FM module must be connected before completing this step.
FM R
emote Learn. Learns the optional 2-way FM transmitter. Press Button 2 on the 1-way remote to
enter FM Transmitter learn mode, then press transmitter Button 1 on each FM remote (max 2).
*Requires the optional ScyNet FM LCD Pager Module.
17. Ignition 2 Relay Program. Selects one of three operating modes for the Ignition 2 relay output:
Ignition 2, Accessory 2, or Starter 2.
18. Horn Output. When set for Horn Output the horn wire will pulse when the alarm is triggered. When
Ignition 3 Output is selected, the output will activate during remote start to trigger a relay for Ignition 3.
19. Turbo Timer. When enabled, if the emergency brake has been applied Ignition power will be kept On
for a predetermined time (2min. Factory Default) from the application of the emergency brake.