Filter
Top Products
Engine Oil
Checking Engine Oil
It is a good idea to check the
engine oil level at each fuel fill. In
order to get an accurate reading, the
oil must be warm and the vehicle
must be on level ground.
The engine oil dipstick handle is a
yellow loop. See Engine
Compartment Overview on
page 5-12 for the location of the
engine oil dipstick.
1. Turn off the engine and give the
oil several minutes to drain back
into the oil pan. If this is not
done, the oil dipstick might not
show the actual level.
2. Pull the dipstick and clean it with
a paper towel or cloth, then push
it back in all the way. Remove
it again, keeping the tip down and
check the level.
When to Add Engine Oil
If the oil is below the MIN (minimum)
mark, add at least one quart/liter
of the recommended oil. This
section explains what kind of oil to
use. For engine oil crankcase
capacity, see Capacities and
Specifications on page 5-86.
Notice: Do not add too much
oil. If the engine has so much oil
that the oil level gets above the
upper mark that shows the proper
operating range, the engine could
be damaged.
See Engine Compartment Overview
on page 5-12 for the location of
the engine oil fill cap.
Add enough oil to put the level
somewhere in the proper operating
range. Push the dipstick all the
way back in when through.
5-14 Service and Appearance Care