Filter
Top Products
To raise the seatback:
1. Lift the recliner lever, located on
the outboard side of the seat,
up fully and push up on the
seatback.
2. Continue raising the seatback
until the seatback re-engages.
{ CAUTION
If either seatback is not locked, it
could move forward in a sudden
stop or crash. That could cause
injury to the person sitting there.
Always push and pull on the
seatbacks to be sure they are
locked.
3. Push and pull on the seatback to
make sure it is locked in place.
The recliner lever is also used
to recline the seatback while a
passenger is seated. See Reclining
Seatbacks on page 1-6.
Rear Seats
Split Folding Rear Seat
The rear split bench seatbacks
can be folded forward, upright,
or partially reclined, independent
of the other seatback position.
{ CAUTION
If either seatback is not locked, it
could move forward in a sudden
stop or crash. That could cause
injury to the person sitting there.
Always push and pull on the
seatbacks to be sure they are
locked.
{ CAUTION
A safety belt that is improperly
routed, not properly attached,
or twisted will not provide the
protection needed in a crash.
The person wearing the belt could
be seriously injured. After raising
the rear seatback, always check
to be sure that the safety belts
are properly routed and attached,
and are not twisted.
To fold the seatback down:
Notice: Folding a rear seat with
the safety belts still fastened may
cause damage to the seat or the
safety belts. Always unbuckle the
safety belts and return them to
their normal stowed position
before folding a rear seat.
1. Unbuckle all three safety belts
and put the front seatback in
an upright position.
Seats and Restraint System 1-9