Filter
Top Products
To lower the rear seatback, pull on the seat tab located
on the outboard side of the seatback cushion and
fold the seatback down. This allows access to the trunk.
To raise the rear seatback pull the seatback up and
make sure it latches. Push and pull on the seatback
to be sure it is locked in position. Make sure that
the safety belts are properly stowed over the seatback
in all three positions.
{CAUTION:
A safety belt that is improperly routed, not
properly attached, or twisted will not provide
the protection needed in a crash. The person
wearing the belt could be seriously injured.
After raising the rear seatback, always check
to be sure that the safety belts are properly
routed and attached, and are not twisted.
{CAUTION:
If the seatback is not locked, it could move
forward in a sudden stop or crash. That could
cause injury to the person sitting there. Always
push and pull on the seatback to be sure it
is locked.
When the seat is not in use, it should be kept in the
upright locked position.
1-9