Filter
Top Products
ENGINE AND PERIPHERALS
Overhauling the engine
10
10-95
For engine sump with reinforcing plate
Refitting
Remove all traces of grease from the cylinder block
and the reinforcing plate with brake cleaner (for
example).
Fit two threaded rods (T) ∅ 7 length 30 mm and cut a
groove at the end of one rod with a hacksaw.
Put a blob of RHODORSEAL 5661 where bearing
caps 1 and 5 are joined to the cylinder block. Do not do
this if the injection was done using butyl seals.
Position the oil pump control shaft, circlip on the oil
pump side.
91510R
89197R1