Filter
Top Products
5
REPAIR AND MAINTENANCE
q Chain and Rear Tire Replacement
Tools required: 10mm wrench, two (2) 8mm wrenches, and two (2) 17mm wrenches.
2 With a 10mm wrench,
loosen the brake cable anchor
and disconnect the cable.
3 With two 8mm wrenches,
loosen brake housing anchor
and disconnect. Keep the spacer
and washers together.
5 With two 17mm wrenches,
loosen the axle. Push the wheel
forward to loosen the chain
and remove from rear and front
sprocket.
Note: Your hands will get
greasy doing this.
6 Pull the wheel out. Note the
arrangement of the hardware
sequence.
7 Install the new chain or
wheel by slipping the chain
around the axle. Slide the axle
into the slots on the frame.
Maneuver the chain onto the
rear sprocket and front sprocket.
10 To hook up the brake hous-
ing anchor, align the cable guide
adjuster and install the spacer
and bolt. Do not tighten until
final step.
11 Install the brake spring
and thread the cable wire into
the cable anchor. Thread the
cable to its original position and
tighten securely.
12 Tighten the brake housing
anchor securely. Re-attach
the chain guard. Test ride and
check. Readjust as needed.
1 Loosen screws and remove
chain guard.
4 Loosen and remove both axle
adjuster nuts.
8 Slide rear frame cap on axle
adjuster bolt.
9 Start screwing on both nuts
alternating 1/8 to 1/4 turn at a time
until chain is properly tensioned.