Filter
Top Products
36
© 2005 directed electronics—all rights reserved
interpreting zone diagnostics
Warn Away responses are not reported by arming or disarming
diagnostics. If you receive a Bypass notification when arming or
a Tamper Alert notification when disarming, look at the LED in
the car. Active or triggered zones will be indicated by a pattern of
blinks by the LED.
Example
If zone 3 was active or triggered, the in-vehicle status LED will
blink three times with a two-second pause. Then it will blink
three times again, and repeat until the ignition is turned on.
ccooddee hhooppppiinngg
The receiver and 2-way remotes use a mathematical formula
called an algorithm to change their code each time the 2-way
remote is used. This technology has been developed to increase
the security of the unit. The control unit knows what the next codes
should be. This helps to keep the 2-way remote “in sync” with the
control unit even if you use the remote control out of range of
the vehicle. However, if the remote has been pressed many times
out of range of the vehicle, or the battery has been removed, it may
note: Your system stores the last two triggered zones in
memory. If your system has been triggered but the in-
vehicle status LED has been reset by turning on the igni-
tion, your dealer can still recall the last two zones that
were triggered. Contact your dealer for details.
➜