Filter
Top Products
21
© 2005 directed electronics—all rights reserved
and know where the Valet button is located. Be sure to check
with your installer at the time of installation for both the location
and the preset response (1-5 presses) of the Valet button.
To disarm the security system,
turn the ignition to the ON posi-
tion. Press and release the Valet
button the preset number of times
(one to five times) within 15 seconds. After five seconds, the system
will disarm. If the system does not disarm, you may have waited too
long; turn the ignition Off and On and try again.
Location of Valet Button_________________________________
Number of Presses_____________________________________
The remote will indicate disarm notification with 2 beeps and 3
flashes of the Orange LED.
silent mode
To temporarily turn off the vehicle’s arm or disarm chirps, use
Silent Mode™. Simply press for less than 1-second before
arming or disarming, and the confirmation chirp(s) will be elim-
inated for that one operation only. If you want the arm/disarm
chirps turned off permanently, your dealer can do this for you.
➜
important! The Valet
®
button can be programmed to
respond to 1-5 presses for the disarm function. You must
check with the installer to verify the programming for
your individual unit.
DRW-35