Filter
Top Products
23
© 2005 directed electronics—all rights reserved
To enter or exit Valet Mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet
button once within 10 seconds.
The in-vehicle status LED will light solidly if you are entering
Valet Mode, and it will go out if you are exiting Valet Mode.
The remote will respond with 3 Orange LED flashes on entering
and 2 beeps and 3 Orange LED flashes on exiting Valet Mode.
To enter or exit Valet Mode using the 2-way remote:
1. Open any vehicle door.
2. Press .
3. Press .
4. Press again.
The in-vehicle status LED will light solidly if you are entering
Valet Mode, and it will go out if you are exiting Valet Mode. The
remote responds with the normal arm/disarm notifications with
each remote button press.
remote start
This feature allows you to remotely start and run your vehicle for
a programmable period of time. This makes it possible to warm
up the engine, as well as adjust the interior temperature of the ve-
hicle with the climate control system. If interior heating or
cooling is desired, the climate controls must be preset, and the
➜
DRW-35