Filter
Top Products
15
© 2004 directed electronics, inc.
The remote will indicate disarm notification with 2 beeps and 3
flashes of the Orange LED. If disarming after the system has
been triggered, the remote control will send a diagnostic notifi-
cation as a reminder. These diagnostic notifications are:
1. If a sensor triggered the system, the remote will beep 4-times
and the Orange and Red LEDs flash 3 times.
2. If a switch (Zone 1, 3, 5, or 6) triggered the system, the
remote will beep 4-times, the Orange LED will flash 6-times
and Red LED will illuminate for 3 seconds.
3. If the system was triggered so many times that NPC is active
the remote will emit the above notifications with 5 beeps
instead of 4.
high security disarm
This system includes High Security Disarm feature. If the system
is triggered this feature allows the user to silence the siren and
reset the system to the armed state without having to visually
checking the system status.
After receiving an alarm page:
1. First press any button on the remote to clear the alarm page.
2. Press either the or button again and the High
Security disarm feature will be activated. The siren will be
silenced and the system will reset to the armed state.
3. Pressing the button once more will fully disarm the
system and allow the vehicle to be accessed.
➜