Filter
Top Products
14
© 2004 directed electronics, inc.
After each press of the to reach the next level of security, the
remote will emit normal arm notification (1 beep and 3 flashes
of the Orange LED). For easiest operation in reaching each level
of security, press immediately
aafftteerr
each notification.
arming while driving
Your security system can be armed while driving the vehicle! Simply
press on the 2-way remote for two seconds while the vehicle is
running. The siren will chirp once to indicate that the security
system is armed, and then once more to indicate that the ignition is
on. The system will not respond to any input except the door trig-
gers, and the starter kill relay (if installed) will not be activated. Once
you have arrived at your destination, the system can be disarmed by
pressing the or by turning the ignition Off. The siren will chirp
twice and the in-vehicle status LED will then stop flashing. The
system can also be disarmed at any time by pressing
..
The remote will respond with the normal arming response plus a
diagnostic notification because the ignition On. When disarmed
the remote will respond with the normal disarming response.
disarming
To disarm the security system, press . You will hear two
chirps, and the parking lights will flash twice. If the power locks
are controlled by the system, the doors will also unlock. The
siren chirping either four or five times when disarming indicates
Tamper Alert, which is described in the Diagnostics Section of
this guide.
➜
➜