Filter
Top Products
25
© 2008 Directed Electronics. All rights reserved.
To enter turbo timer mode with a manual transmission:
Perform the manual transmission procedure (See p. 22) with the door open.
Transmit the timer mode feature with the remote by pressing two-times, and
then press
A U
X
.
After exiting the vehicle, lock the system and the vehicle remains running for the
programmed runtime. (The remote start feature is still enabled).
You can still remote start the vehicle after the turbo timer has timed out and
shut Off the vehicle. For safety reasons, if a door is opened (while the system
is Locked or Unlocked) while you are away, the remote start exits the manual
transmission mode and will not remote start until the MTS sequence is re-
initiated.
Note: An optional push button can be hardwired to the (-) activation input
(H1/10) on the remote start module if you want to activate the turbo timer
without using the remote.
When the vehicle is running follow the procedures listed above, but instead
of pressing the remote, press the push button the appropriate number of times
to activate the remote start (factory setting is for 1 pulse). After which you can
turn Off the ignition and exit the vehicle. The car remains running for the pre-
programmed amount of time.
➤ Smart start activation
With Smart Start the remote start automatically activates when the vehicle
reaches a certain temperature, or when it reaches a certain voltage.
Note: This feature works only when the system has been locked with the
remote.
The factory setting for temperature high is 100º, and the low is 0º (F). The
voltage setting is 10.5v. These settings can be adjusted or turned off by your
installer using the Bitwriter.