Filter
Top Products
The vehicle may be driven at a reduced speed while
this message is on, but acceleration and speed may be
reduced. Anytime this message stays on, the vehicle
should be taken to your dealer/retailer for service
as soon as possible.
This message displays only when the ignition is in
ON/RUN. A chime sounds for two seconds while this
message is displayed. Press the set/reset button
to acknowledge this message and to clear it from
the screen.
This message continues to display if it has not
been acknowledged when the engine is turned off.
It also re-displays for three seconds if the message
has been acknowledged, but the condition still exists
when the engine is turned off.
If the condition still exists, the message re-appears
when the engine is turned on.
REMOTE START ACTIVE PRESS
HAZARD SWITCH TO CANCEL
If your vehicle has the remote start feature, this
message displays when a remote start is initiated.
If you would like to cancel the remote start, turn on
the hazard warning flashers. See Hazard Warning
Flashers on page 3-6.
REMOTE START DISABLED
If your vehicle has the remote start feature, this
message displays if a remote start attempt is
unsuccessful. This may be caused if any of the
following conditions are true when a remote start
attempt is made:
• The remote start system is disabled
through the DIC.
• The key is in the ignition.
• The hood or the doors are not closed.
• There is an emission control system malfunction.
• The engine coolant temperature is too high.
• The oil pressure is low.
• The hazard warning flashers are turned on.
• The maximum number of remote starts or
remote start attempts between ignition cycles
has been reached.
• The content theft-deterrent alarm is on while
attempting to remote start the vehicle.
See “REMOTE START” under DIC Vehicle
Customization on page 3-89 and Remote Vehicle
Start on page 2-7 for more information.
3-79