Filter
Top Products
Care of the HUD
Clean the inside of the windshield as needed to remove
any dirt or film that could reduce the sharpness or
clarity of the HUD image.
To clean the HUD lens, use a soft, clean cloth that
has household glass cleaner sprayed on it. Wipe the
HUD lens gently, then dry it. Do not spray cleaner
directly on the lens because the cleaner could leak
into the unit.
If You Cannot See the HUD Image
When the Ignition Is On
• Is anything covering the HUD lens?
• Is the HUD dimmer setting bright enough?
• Is the HUD image adjusted to the proper height?
• Are you wearing polarized sunglasses?
• Still no HUD image? Check the fuse in the
instrument panel fuse block. See Instrument
Panel Fuse Block on page 5-122.
If the HUD Image Is Not Clear
• Is the HUD image too bright?
• Are the windshield and HUD lens clean?
If the HUD image is not correct, contact your
dealer/retailer.
Keep in mind that the windshield is part of the HUD
system. See Windshield Replacement on page 5-61.
Accessory Power Outlet(s)
The vehicle has
two 12-volt outlets
which can be used
to plug in electrical
equipment.
One accessory power outlet is located on the center
console, below the front edge of the storage console.
The other is located inside the console.
Remove the tethered cap to use the outlet. When
not using the outlet, be sure to cover it with the
protective cap.
3-26