Filter
Top Products
90
MAINTENANCE
Brakes
Hydraulic Brake Inspection
Inspect the brake lever reserve before each use of the snowmobile. See
page 58.
Brake pads must be replaced when the brake pad material becomes thin-
ner than the backing plate (approximately 1/16 inch or 1.5 mm). A kit is
available for replacing brake pads. See your dealer.
WARNING! Brake failure during operation can result in serious injury or death.
Properly functioning brakes are vital to your safety. Be sure the brake pads do
not drag on the disc and that brake lever travel is not excessive. Always replace
brake pads when the brake pad material becomes thinner than the backing plate
(approximately 1/16 inch or 1.5 mm).
Brake Components
1. Brake Caliper
2. Brake Disc
3. Brake Pad Material (Replace
when thickness is less than
1/16 inch or 1.5 mm).
4. Anti-rattle springs (come
with brake pad kit)
Excessive Lever Travel
Hydraulic brakes are self-adjust-
ing, but if excessive brake pad
clearance develops, bring the
snowmobile to an authorized
POLARIS dealer for inspection
and adjustment.
2
1
3
4