Filter
Top Products
37
FEATURES
Instrument Cluster
Rider Information Center
Security System (Ignition Lock System)
This system is an optional feature and will not function until it has been
activated by your authorized POLARIS dealer. If you have this feature
activated, you can lock the ignition to prevent unauthorized use when
leaving the snowmobile unattended. A locked system will limit engine
speed to 3000 RPM, which prevents clutch engagement, and the snow-
mobile will not move when throttle is applied. If you wish to use this
feature, you must complete all four tasks on the following pages to have
your system activated and to change the security code to one of your
own choosing.
First Time Use of Your Security System
Perform all tasks in the order shown if you wish to activate
and use the optional security system.
TASK 1: Activate the security system
See your authorized POLARIS dealer to have the optional security system
feature activated in the electronic control unit (ECU).
TASK 2: Lock the System the First Time
1. Start the engine and lock the parking brake.
2. Press and hold the MODE and SET buttons for 3
seconds, then release. SECURE OFF should be
displayed. If not, repeat this step.
3. Wait until ENTER displays, then press and
release SET to advance the digit. When “0” is
displayed, press and release MODE to accept
the digit. TIP: If the ENTER screen exits due to
inactivity, repeat step 2.
4. Press and release SET to advance the second
digit. When “0” is displayed, press and release
MODE to accept the digit.
5. Press and release SET to advance the third digit.
When “0” is displayed, press and release MODE
to accept the digit.
6. After accepting the third digit, view the display
screen. SECURE ON displays if the system locks.
NOTE: The system is now locked.
7. You must now unlock the system. Proceed
immediately to TASK 3.