Filter
Top Products
52
OPERATION
Starting the Engine
Starting a Cold Engine
WARNING
Engine exhaust contains poisonous carbon monoxide and can
cause loss of consciousness resulting in severe injury or death.
Never run an engine in an enclosed area.
1. Place the transmission in PARK and
lock the parking brake. Make sure the
fuel valve is on.
2. Sit on the vehicle and pull the choke
knob (1) out until it stops. If t he knob
doesn’t stay where positioned, increase
the tension by rotating the tension
adjusting nut (2) clockwise.
NOTE: The variable choke is fully on when
the knob is pulled completely out.
The choke is off when the knob is
pushed completely in. The choke
can be adjusted gradually, depending
on how much choke is needed for
starting. Be sure the choke is off during operation, as excess
fuel washing into the engine oil will increase wear on engine
components.
3. Move the engine stop switch to RUN.
NOTE: Do not press the throttle while starting the engine.
4. Turn the ignition key past the ON position t o engage the starter for
a maximum of five seconds. Release t he key when the engine
starts. If it doesn’t start, release the key and wait five seconds.
Activate the starter for another five seconds. Repeat until the
engine starts.
5. If the engine slows or stops, position the choke knob half way in to
allow proper engine warm up.
6. Vary the engine RPM slightly with the throttle to aid in warm-up.
When the engine idles smoothly, push the choke all the way in.
CAUTION
Operating the vehicle immediately after starting could cause
engine damage. Allow the engine to warm up for several minutes
before operating the vehicle.
1
2