Polaris FS Classic Offroad Vehicle User Manual


 
82
OPERATION
Electronic Reverse (PERC 4t)
Electronic reverse will activate only when the vehicle is stopped and
engine speed is below 2500 RPM. Maximum engine speed when
operating in reverse will be 6000 RPM.
WARNING
Improper reverse operation, even at low speeds, may cause loss
of control, resulting in serious injury or death. Damage will occur
to the gearcase or transmission if shifting is attempted when the
engine is operating above idle speed.
S Shift to or from reverse only when the snowmobile is stopped
and when engine speed is at idle.
S Look behind the snowmobile before and while backing.
S Avoid sharp turns.
S Apply throttle slowly.
Engaging Reverse
1. Stop the snowmobile and leave the
engine idling.
2. Make sure the area behind your
snowmobile is clear.
3. Push the yellow reverse button on t he
left-hand control for one second, then
release.
NOTE: A reverse light on the instrument panel will indicate that the
snowmobile is in reverse.
4. Apply the throttle slowly to make sure the snowmobile is in
reverse.
NOTE: If the engine stops running, the snowmobile will be in forward
gear when it’s restarted.
Disengaging Reverse
1. Stop the snowmobile and leave the engine idling.
2. Push the yellow reverse button for one second and release. The
light on the instrument panel will shut off.
3. Apply the throttle slowly to make sure the snowmobile is in
forward.
L