Filter
Top Products
11:00
2:00
+
118
MAINTENANCE
Clutch System
Drive Belt Removal
CAUTION
Do not attempt to remove the drive belt after operating i n reverse.
The snowmobile must be stopped after forward motion to prevent
damage to components during belt removal.
1. Stop the engine after operating in a forward motion.
NOTE: For easier accessibility, make sure the clutch tool access
hole (
+) is visible between the 11:00 and 2:00 positions of
the clutch sheave.
2. Turn the ignition key off.
Wait for the engine to come
to a complete stop.
3. Lock the parking brake.
4. Open the hood.
5. Remove the left side panel.
6. Locate the L-wrench in the
tool kit. Install the wrench
into the open threaded
access hole
(+) in the outer
sheave of the clutch.
7. Turn the wrench clockwise until the sheaves open far enough to
remove the belt.