Polaris FS Classic Offroad Vehicle User Manual


 
74
OPERATION
Break-In Period
The break-in period for your new Polaris snowmobile is the first 500
miles (800 km) of operation. No single action on your part is as
important as following the procedures for a proper break-in. Careful
treatment of a new engine and drive components will result in more
efficient performance and longer life for these components.
CAUTION
Excessive heat build-up during the first 500 miles (800 km) o f
operation will damage close-fitting engine parts. Do not operate at
full throttle or high speeds for extended periods during the
break-in period.
Use of non-recommended oil may cause serious engine damage.
Always use the recommended oil for your Polaris snowmobile.
1. Fill the fuel tank with the recommended fuel. See page 79.
2. Check the oil level in the oil tank. See page 92. Add oil if
necessary to maintain at the recommended level.
3. Drive slowly at first. Vary the throttle positions. Do not operate at
sustained idle.
4. Perform regular checks on fluid levels, controls and areas outlined
on the daily pre-ride inspection checklist. See page 64.
5. During the break-in period, change both the oil and the filter at 500
miles or before seasonal storage, whichever comes first.