Filter
Top Products
57
THE PERFECT FIT
Traction Products
n
Carbide Skags
A skag is a replaceable bar a ttached to the underside of the ski to assist
in turning the snowmobile and t o prevent ski wear caused by contact
with roads and other bare terrain. Use carbide skags with studded
tracks to help maintain proper vehicle steering and control. See page
111.
If your machine has carbide skags, it may be necessary to add track
studs to maintain proper vehicle control. Maintain a proper balance
between the number of studs and the length of carbide on the skags
(the more studs you use, the longer the carbide on the skags should be).
See your dealer’s track studding chart.
Wear Strips
To avoid excessive tunnel wear, tunnel wear strips must be installed
whenever track studding is used. Install Wear Strip Kit P/N 2874687.
Wear strips are designed for a specific stud length. See your dealer ’s
studding chart for recommende d traction accessories.
CAUTION
Whenever wear strips are relocated, be sure there’s adequate
stud clearance to the heat exchangers. Lack of clearance may
result in damage to heat exchangers.