Filter
Top Products
33
FEATURES
Instrumentation
MFD Digital Display Programs
Performance Program
Clock Setting
1. While in the CLOCK display, press
and hold the SET button for five
seconds.
2. When the hour starts flashing press
the SET switch once to advance one
hour, or press and hold the SET
button to advance the hour once
every 0.2 seconds.
3. Press the MODE button to save the hour and flash the minutes.
4. Set the minutes in the same manner.
5. When finished, press the MODE button to save the new setting.
NOTE: If the MODE button is not pressed within ten seconds, the
clock will automatically save the new entry.
Engine Program
The Engine Program automatically displays the engine coolant
temperature, engine hours, electrical system voltage level and fuel
level. On machines equipped with altimeter sensor and ambient air
temperature sensors, altitude and ambient air temperature will display
as additional screens in the engine program. P ress the SET button to
display the ambient air temperature and altitude screens (if equipped).
Air Temperature (if equipped)
The MFD displays actual air temperature.
Press and hold the MODE switch for ten
seconds to switch between standard and
metric units of measurement.