Filter
Top Products
68
MAINTENANCE
Handlebars
WARNING! Improper adjustment of the handlebars or incorrect torquing of the
adjuster block tightening bolts can cause limited steering or loosening of the
handlebars, resulting in loss of control and serious injury or death. Follow the
adjustment procedures exactly, or see your Polaris dealer for service.
The handlebars can be adjusted for rider preference.
1. Remove the handlebar cover.
2. Loosen (do not remove) the four
handlebar clamp bolts.
3. Adjust the handlebar to the
desired height.
4. Be sure the handlebars do not
contact the gas tank or any other
part of the machine when turned
fully to the left or right.
5. Torque the front two bolts to 14-17 Nm, then torque the rear two
bolts.
Tip: A gap of up to 3 mm should remain at the rear bolts.
Handlebar Bolts