Polaris 500 2X4 International Offroad Vehicle User Manual


 
34
OPERATION
Starting the Engine
1. Position the vehicle on a level surface outdoors or in a well-venti-
lated area.
2. Place the transmission in neutral.
3. Lock the parking brake.
Tip: The starter interlock will prevent the engine from starting if the transmission
is in gear and the brake is not engaged.
4. Turn the fuel valve on.
5. Sit on the vehicle.
Tip: Do not use the choke if starting a warm engine. Excessive use of the choke
can cause the spark plug to become wet fouled.
6. If the engine is cold, pull the
choke knob out until it stops. If
the knob doesn't stay where
positioned, increase the ten-
sion by rotating the tension
adjusting nut clockwise.
Tip: The variable choke is fully on when
the knob is pulled completely out.
The choke is off when the knob is
pushed completely in. The choke
can be adjusted gradually, depend-
ing on how much choke is needed
for starting. Be sure the choke is off
during operation, as excess fuel
washing into the engine oil will
increase wear on engine compo-
nents.
7. Move the engine stop switch to RUN.
8. Do not press the throttle while starting the engine.
Choke
Knob
Adjusting
Nut