Filter
Top Products
64
MAINTENANCE AND LUBRICATION
Engine Oil
Oil Pump Priming (2x4, 4X4)
This priming procedure must be
performed whenever t he oil hose
connection between the oil tank
and pump inlet has been
disconnected.
1. Clamp or pinch off the vent
line (1) approximately 2I
from the oil t ank (2), b etween
the end of the oil tank vent
fitting and the vent line’s
pressure relief slit (3).
2. Run t he engine for 15-20 seconds.
3. Remove the vent line clamp.
The oil pump will now be
properly primed and ready for
operation.
2I
1
2
3