Filter
Top Products
112
MAINTENANCE
General Maintenance
Drive Belt Removal
1. Stop the engine after operating in a forward motion.
2. Turn the ignition key off. Wait for the engine to stop completely.
3. Lock the parking brake (if equipped).
4. Open the hood.
5. Remove the clutch guard retain-
ing pin and open the clutch
guard.
6. Standard Clutch: Skip to step
8.
7. TEAM Clutch: Locate the L-
wrench in the tool kit and install
it into the open threaded hole in
the outer sheave of the clutch.
Rotate the wrench until the
sheaves open far enough to
remove the belt.
8. Firmly grasp the belt midway between the clutches and pull upward
and rearward to remove. See illustration.
CAUTION
Do not attempt to remove the drive belt after operating in reverse. The snow-
mobile must be stopped after forward motion to prevent damage to compo-
nents during belt removal.